Dear Kenwood Customer:

Thank you for your e-mail.  This is simple directions for programming your TM-V7A.......

1. Push the VFO button
2. Enter your desired frequency
3. Push the TONE button until the T shows in the display for repeaters with PL/Encode
4. Push F button then SHIFT to select your + or - offset
5. Push and hold the F button for at least 2 seconds, it will beep twice, and the F will flash
6. Push the T. SEL button, at this time the PL/Encode number will appear (example 88.5)
    turn the main tuning knob to select the desired PL/Encode.
7. To store all this information into Memory, push the F button, and when the memory numbers 
    come up above the frequency display turn the main tuning knob to the desired Memory of your choice.
    Immediately push the MR button to store the information.
8. To recall that memory just push MR again. 
    



  

If you need further assistance, please e-mail us again.

Sincerely,
Kenwood Amateur Radio Customer Support